Walkway bridge 2 is what i get when i pasteclip the file into one of my standard templates.
Walkway bridge 1 is my original drawing file that went beserk. I attached 2 jpegs of what I'm trying to explain above, i appologize if i failed horribly at trying to explain this. Imagine drawing something on a piece of paper and then you rotate that piece of paper so your looking at it from the thin edge. It looks like my model space flipped 90 degrees to what I was working on before. The problem is the items I drew are represented as a line. I did a copybase on the items I need to revise and then I did a pasteclip to import the drawing into my new template. In an attempt to keep moving forward and not waste too much time i opened up a new drawing template. I got frustrated trying to figure out what I did so I chalked it up as maybe the file is too large and something went haywire. I was revising a small walkway bridge for one of my projects and all of the sudden my polar array would only allow me to draw a ray in either the 0 or 180 direction even though it's set at increments of 15 degrees. I just ran into a problem with AutoCAD lt 2014 that I have never seen before and I'm hoping someone may be able to help.